1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. AKin3d
    Post

    Answered Bed wont heat up...

    You were correct, not firmware issue. More like I'm an idiot and the connections were loose. I just purchased a SSR so after I install that I...
    Post by: AKin3d, May 21, 2017 in forum: Troubleshooting
  2. AKin3d
    Thread

    Answered Bed wont heat up...

    I recently installed a Discount Smart Controller LCD to my Robo 3d R1 plus. I had a lot of difficulty in the process. I eventually bought a new...
    Thread by: AKin3d, May 21, 2017, 2 replies, in forum: Troubleshooting
  3. AKin3d
    Post

    Full Graphics LCD Controller - blank screen

    Ok I started from scratch. COM port is correct as well as the board type Unzipped The robo3dr1plusv2.zip. Than I opened it up in Arduino and went...
    Post by: AKin3d, May 7, 2017 in forum: General Questions
  4. AKin3d
    Post

    Full Graphics LCD Controller - blank screen

    I followed all the online instructions by removing the // before //#define full_graphics_controller Than I uploaded it to the Arduino,...
    Post by: AKin3d, May 7, 2017 in forum: General Questions
  5. AKin3d
    Post

    Full Graphics LCD Controller - blank screen

    I recently installed the Full Graphic Smart Controller on my R1+. I had a lot of difficulty editing the configure.h line in Arduino. I had issues...
    Post by: AKin3d, May 7, 2017 in forum: General Questions
  6. AKin3d
    Post

    Answered Build Plate connectors burnt up, almost started a fire

    Awesome, yeah I don't shy from a challenge. As my mother always said, you only regret the shots you don't take. Ill hunt down a good ramps board...
    Post by: AKin3d, Apr 24, 2017 in forum: Troubleshooting
  7. AKin3d
    Post

    Answered Build Plate connectors burnt up, almost started a fire

    I was thinking that might be the problem. What would you recommend as a replacement for the ramps board? Can I find one online or will I have to...
    Post by: AKin3d, Apr 24, 2017 in forum: Troubleshooting
  8. AKin3d
    Thread

    Answered Build Plate connectors burnt up, almost started a fire

    So my build plate was having issues heating up. I removed the base and wiggled the connection a little bit and it started working again. I started...
    Thread by: AKin3d, Apr 24, 2017, 7 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again