1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. curiousjoi
    Post

    Unresolved X-Offset Broken

    ok i tried doing some adjustments but after playing with it some more i realized - the motor doesnt move at all just shakes. [MEDIA] the motor...
    Post by: curiousjoi, Jan 19, 2020 in forum: Troubleshooting
  2. curiousjoi
    Post

    Unresolved X-Offset Broken

    hello - I finally got around to doing this, ordered everything listed in this thread and it's still not working.... Right now the X moves but...
    Post by: curiousjoi, Jan 19, 2020 in forum: Troubleshooting
  3. curiousjoi
    Post

    Unresolved X-Offset Broken

    I was able to unbolt the x stepper and was about to replace the new one but notice I don’t have the belt holder on... is there a way to remove...
    Post by: curiousjoi, Jan 14, 2020 in forum: Troubleshooting
  4. curiousjoi
    Post

    Unresolved X-Offset Broken

    I received the motor parts but I'm not sure as to which one I should be changing.
    Post by: curiousjoi, Jan 14, 2020 in forum: Troubleshooting
  5. curiousjoi
    Post

    Unresolved X-Offset Broken

    Thanks! I ordered the set assuming I have to replace all three of the motors. Amazon prime so should arrive fast - I will report back once they...
    Post by: curiousjoi, Jan 13, 2020 in forum: Troubleshooting
  6. curiousjoi
    Post

    Unresolved X-Offset Broken

    I did another wire swap and this time with the Y and the X wire. The stepper doesn't move when I hit the Y offset but the bed moves when I hit the...
    Post by: curiousjoi, Jan 13, 2020 in forum: Troubleshooting
  7. curiousjoi
    Post

    Unresolved X-Offset Broken

    :) When I did the wire swap, the cranks that feed the filament (sorry I don't know the real term) start spinning than when I switch it back to...
    Post by: curiousjoi, Jan 12, 2020 in forum: Troubleshooting
  8. curiousjoi
    Post

    Unresolved X-Offset Broken

    Sorry about that... When I hit the home function, the bed moves, the Y and Z offset move but the X offset remains where It is. None of the screws...
    Post by: curiousjoi, Jan 12, 2020 in forum: Troubleshooting
  9. curiousjoi
    Post

    Unresolved X-Offset Broken

    No noise from the x stepper and it doesn't move at all
    Post by: curiousjoi, Jan 12, 2020 in forum: Troubleshooting
  10. curiousjoi
    Post

    Unresolved X-Offset Broken

    The belts arent even trying to move haha. It finished the print and I've closed the program re-opened it and re-"installed" the drivers and still...
    Post by: curiousjoi, Jan 12, 2020 in forum: Troubleshooting
  11. curiousjoi
    Thread

    Unresolved X-Offset Broken

    I'm so close to finishing a print job but now my Robo 3D plus does not move left and right anymore :( I ran g29 and it says that the x is moving...
    Thread by: curiousjoi, Jan 12, 2020, 26 replies, in forum: Troubleshooting
Showing results 1 to 11 of 11
Search Again