1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Adam Laird
    Thread

    3rd Party App/Plugin Camera Access

    Is there anyone using the telegram plugin on the R2? I’m not sure how to give it access to my camera so it can send me pictures of my prints. I’ve...
    Thread by: Adam Laird, May 13, 2018, 3 replies, in forum: General Questions
  2. Adam Laird
    Thread

    AstroPrint Plug-in with Octoprint?

    Has anyone been using the AstroPrint plug in to remotely monitor your R2? I’ve been trying to get it running on my printer, but I need...
    Thread by: Adam Laird, Mar 7, 2018, 6 replies, in forum: Software
  3. Adam Laird
    Thread

    E3D block with Robo Hexagon?

    I just ordered a new hot end from Robo because mine looks like it’s leaking a bit around the heatbreak and nozzle. The heater cartridge is moving...
    Thread by: Adam Laird, Mar 5, 2018, 6 replies, in forum: General Questions
  4. Adam Laird
    Thread

    BuildTac FlexPlate on V2 bed?

    Has anyone tried installing the BuildTak FlexPlate system on their V2 bed? I’ve been knocking prints off mine with a mallet, and I was wondering...
    Thread by: Adam Laird, Feb 24, 2018, 15 replies, in forum: Mods and Upgrades
  5. Adam Laird
    Thread

    Printer Heats and Goes Through Leveling but Then Freezes

    My printer has gone through a lot in the last couple of months. The power supply broke itself and started frying the 7.5 amp fuse on the main...
    Thread by: Adam Laird, Dec 9, 2017, 6 replies, in forum: Troubleshooting
  6. Adam Laird
    Thread

    Totally Dead/Fried Printer?

    I knew I didn't have enough filament to finish my print, but there wasn't enough to bother stopping the print and save it so I let my R2 run...
    Thread by: Adam Laird, Oct 8, 2017, 19 replies, in forum: Troubleshooting
  7. Adam Laird
    Thread

    Serious Jam

    I was running some purple esun filament that had been printing fine and now my printer is totally jammed. I've cranked the hotend up to 250 and...
    Thread by: Adam Laird, Aug 12, 2017, 11 replies, in forum: Troubleshooting
  8. Adam Laird
    Thread

    New PEI Sheet for the Bed?

    Has anyone replaced the PEI sheet on their print bed? I tried using some of my sisters M3D tough ink and it failed and left some residue...
    Thread by: Adam Laird, Jul 30, 2017, 0 replies, in forum: General Questions
  9. Adam Laird
    Thread

    Larger Nozzle?

    I just got R2 on Wednesday (I was a pre-order person) and so far it's working really well! I've been working on a few bigger lower resolution...
    Thread by: Adam Laird, Jul 7, 2017, 8 replies, in forum: General Questions
Showing results 1 to 9 of 9
Search Again