1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Carlos Garcia
    Thread

    Robo C2 Touch Screen

    Just finished a print, went to do the next one touch in the file icon, screen changed and got stock, stoped working I’m not able to use my printer...
    Thread by: Carlos Garcia, Jun 8, 2020, 6 replies, in forum: General Questions
  2. Carlos Garcia
    Thread

    Cura 4.6.1

    Hey everyone, Im trying to upgrade Cura, still using Cura 2.5.0 as is the only one I can get to work. I can't add my Robo C2 as its not on the...
    Thread by: Carlos Garcia, Jun 1, 2020, 8 replies, in forum: Software
  3. Carlos Garcia
    Thread

    Solved poor Printing Quality

    I have tried everything, Aligning rods, unclog hot end Im still getting poor, air print, printing quality. I'm about to throw My printer in the...
    Thread by: Carlos Garcia, Jan 18, 2019, 39 replies, in forum: Troubleshooting
  4. Carlos Garcia
    Thread

    Partial Answer Bad print quality air print

    hello people, hope your all doing well, I’m having trouble with Robo C2 print quality looks like air gaps. Can anybody please help?
    Thread by: Carlos Garcia, Mar 13, 2018, 8 replies, in forum: Troubleshooting
  5. Carlos Garcia
    Thread

    Lately I have som Clicking Noise

    I have done one 24 hour print and a 12 hour print after that and I'm doing a 6 hour print now and Im getting some clicking sounds any idea what...
    Thread by: Carlos Garcia, May 31, 2017, 8 replies, in forum: General Questions
  6. Carlos Garcia
    Thread

    Sorry if this is a stupid question but why does this happens?

    I have been trying to print a spinner for my girls but this keeps happening, why is ti? Do i have to set something? [MEDIA]
    Thread by: Carlos Garcia, May 27, 2017, 16 replies, in forum: General Questions
  7. Carlos Garcia
    Thread

    Gantry Deviation out of the box

    Just got my C2 and out of the box u notice the gantry clips weren't on properly and I noticed that the gantry was deviated is this normal? should...
    Thread by: Carlos Garcia, May 24, 2017, 5 replies, in forum: Show and Tell
Showing results 1 to 7 of 7
Search Again