1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Dylan Zilifian
    Thread

    Bath Towel Printer Enclosure

    Hello! So basically I have found an inexpensive way to make a printer enclosure. Just put a towel on your printer, making sure all the edges are...
    Thread by: Dylan Zilifian, Feb 18, 2018, 1 replies, in forum: General Questions
  2. Dylan Zilifian
    Post

    Solved R1+ making noise when starting up

    Okay thank you! Probably wont buy one unless I really need to.:D
    Post by: Dylan Zilifian, Aug 9, 2017 in forum: Troubleshooting
  3. Dylan Zilifian
    Post

    Solved R1+ making noise when starting up

    It was the fan in the power supply. Is there any place I could get that same 14v fan? checked E3D and they didn't seem to have the same one. Also...
    Post by: Dylan Zilifian, Aug 9, 2017 in forum: Troubleshooting
  4. Dylan Zilifian
    Post

    Solved R1+ making noise when starting up

    Will look after this current print finishes. Its a 30 hr print so its going to take a while. Thanks!
    Post by: Dylan Zilifian, Aug 5, 2017 in forum: Troubleshooting
  5. Dylan Zilifian
    Thread

    Solved R1+ making noise when starting up

    So whenever I start up the printer it makes a noise and I can't tell what it is. I don't think its a fan because I've already checked them...
    Thread by: Dylan Zilifian, Aug 5, 2017, 7 replies, in forum: Troubleshooting
  6. Dylan Zilifian
    Thread

    Solved E3D nozzle on stock hotend

    Is it possible to put an E3D nozzle on a stock hotend or will I have to buy a new hotend to go with it?
    Thread by: Dylan Zilifian, Jun 15, 2017, 1 replies, in forum: General Questions
  7. Dylan Zilifian
    Post

    Answered Filiment issue

    Also if the gears are turning, than you can also put a little cooking oil on the beginning of your filament to help it start feeding.
    Post by: Dylan Zilifian, Jun 6, 2017 in forum: Troubleshooting
  8. Dylan Zilifian
    Post

    Answered Filiment issue

    Try to manually extrude filament on MatterControl. Do this by going to setting and controls, then clicking on controls. There is an option to...
    Post by: Dylan Zilifian, Jun 6, 2017 in forum: Troubleshooting
  9. Dylan Zilifian
    Post

    Answered New extruder needed

    I would recommend finding one from E3D. If its the hotend you are looking for, then I would recommend getting something along the line of a V6. If...
    Post by: Dylan Zilifian, Jun 6, 2017 in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again