1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Fablac
    Post

    Solved problem printing from full graphic smart controller

    Thank you very much i exported my file with mattercontrol and it worked, i get a nice print!!! Now i know that the settings are in the file, not...
    Post by: Fablac, Jun 26, 2017 in forum: Troubleshooting
  2. Fablac
    Post

    Solved problem printing from full graphic smart controller

    No i did not...i will try tomorrow i hope it will be good, thanks for your help guys!
    Post by: Fablac, Jun 26, 2017 in forum: Troubleshooting
  3. Fablac
    Post

    Solved problem printing from full graphic smart controller

    This is a really good question...i didn't know that the settings were in the gcode file too, i thought the setting were in the arduino (sorry to...
    Post by: Fablac, Jun 26, 2017 in forum: Troubleshooting
  4. Fablac
    Post

    Solved problem printing from full graphic smart controller

    I use slic3r
    Post by: Fablac, Jun 26, 2017 in forum: Troubleshooting
  5. Fablac
    Post

    Solved problem printing from full graphic smart controller

    [ATTACH] This is what i got when i print with my lcd controller with a gcode file. With mattercontrol i got one whole piece not just "zigzags"
    Post by: Fablac, Jun 25, 2017 in forum: Troubleshooting
  6. Fablac
    Post

    Solved problem printing from full graphic smart controller

    Hi thank for your help, yes I m using mattercontrol via USB. But as I said , with USB printing everything is fine
    Post by: Fablac, Jun 25, 2017 in forum: Troubleshooting
  7. Fablac
    Post

    Solved problem printing from full graphic smart controller

    Good morning, Nobody knows the solution..? :(
    Post by: Fablac, Jun 25, 2017 in forum: Troubleshooting
  8. Fablac
    Thread

    Solved problem printing from full graphic smart controller

    Hi everybody, i need your help for my 3d printer robo r1plus. When i print from my computer with mattercontrol, everything is fine but i bought a...
    Thread by: Fablac, Jun 23, 2017, 11 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again