1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. spanishcop
    Thread

    Supports shredding

    Can someone tell me why this is happening? Is it the extruder, my settings or the model? I tried a regular size print that was going to be like...
    Thread by: spanishcop, Nov 17, 2018, 39 replies, in forum: Troubleshooting
  2. spanishcop
    Thread

    TouchPad LED setup

    So I did this a little different. I actually installed tube LEDs and went to Lowes and picked a couple plastic holders to mount on existing...
    Thread by: spanishcop, Nov 15, 2018, 4 replies, in forum: Mods and Upgrades
  3. spanishcop
    Thread

    Cover for Robo R2

    So I decided to make a cover for my Robo R2. Yeah I could have just thrown a towel or some kind of a cloth over it, but I wanted something nice...
    Thread by: spanishcop, Nov 12, 2018, 10 replies, in forum: Mods and Upgrades
  4. spanishcop
    Thread

    Help Please - Filament Feeder Replacement

    Can anyone tell me where I can get a replacement for my filament feeder. I was having a hard time getting filament to feed as the teeth just kept...
    Thread by: spanishcop, Nov 5, 2018, 7 replies, in forum: Troubleshooting
  5. spanishcop
    Thread

    Heating Failed, system stopped. Heater ID: bed

    So the R2 started throwing this error [IMG] When I send file to print from PC with the Robo3d Cura 2.5.0, the bed raises, and everything seems...
    Thread by: spanishcop, Aug 28, 2017, 24 replies, in forum: Troubleshooting
  6. spanishcop
    Thread

    Greetings from Ohio

    Just pre-ordered my Robo R2 and looking forward to participating with everyone else here to learn and share experiences and knowledge. I'm about...
    Thread by: spanishcop, Jun 20, 2017, 3 replies, in forum: United States of America
Showing results 1 to 6 of 6
Search Again