1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Rob Johnson
    Post

    Brand new R2 issues -Wavy Prints

    Just got shipping notice that components are on the way! Very curious to see if this fixes the problem and how easy/difficult the installation...
    Post by: Rob Johnson, Jul 28, 2017 in forum: Troubleshooting
  2. Rob Johnson
    Post

    Brand new R2 issues -Wavy Prints

    Well, it's been radio silence from Robo since they said they were going to send me a replacement leadscrew/motor. Maybe they have but I've asked...
    Post by: Rob Johnson, Jul 28, 2017 in forum: Troubleshooting
  3. Rob Johnson
    Post

    Brand new R2 issues -Wavy Prints

    I had emailed support on Friday and they got back to me today. They're sending a replacement Z-motor/leadscrew assembly which they said was easy...
    Post by: Rob Johnson, Jul 24, 2017 in forum: Troubleshooting
  4. Rob Johnson
    Post

    X and Y Ringing on prints - possible solutions

    John, Did the printed blocks placed under the Z axis motor solve the ringing/sine wave pattern problem? If so, can you upload your design? Thanks!
    Post by: Rob Johnson, Jul 22, 2017 in forum: Troubleshooting
  5. Rob Johnson
    Post

    Brand new R2 issues -Wavy Prints

    The guide rods for the Z are attached to that same piece of plastic the motor/leadscrew combo are attached to as well. The whole thing pulses up...
    Post by: Rob Johnson, Jul 22, 2017 in forum: Troubleshooting
  6. Rob Johnson
    Post

    Brand new R2 issues -Wavy Prints

    Thanks for the quick replies guys! I'll try and figure out how to get the return processed! Hopefully I can get a working machine up & running...
    Post by: Rob Johnson, Jul 22, 2017 in forum: Troubleshooting
  7. Rob Johnson
    Thread

    Brand new R2 issues -Wavy Prints

    Take a look at the attached images. I'm thinking the Z axis lead screw is bent (it wobbles noticeably when the table travels from bottom to top...
    Thread by: Rob Johnson, Jul 22, 2017, 33 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again