1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Gomo2017
    Post

    Answered First layer is too for from the platform.

    I found "Macro"s under "Settings", clicked on .9, it didn't seem to do anything. Then I and ran the print program but it still is too far from...
    Post by: Gomo2017, Jul 27, 2017 in forum: Troubleshooting
  2. Gomo2017
    Thread

    Answered First layer is too for from the platform.

    Using Matter Control, I can't get the first layer on any of my parts to print close to the print platform. The gap is about 1mm. What settings...
    Thread by: Gomo2017, Jul 27, 2017, 14 replies, in forum: Troubleshooting
  3. Gomo2017
    Post

    Solved Build platform on my R1 stopped heating.

    OK thanks, I will look into getting one. Although this printer is still under warranty I don't think I should paying for it. I've only owned it...
    Post by: Gomo2017, Jul 24, 2017 in forum: Troubleshooting
  4. Gomo2017
    Post

    Solved Build platform on my R1 stopped heating.

    The heat bed circuit input measures 12.15 Vdc and the starting temperature is 26.4, the same as the nozzle temperature.
    Post by: Gomo2017, Jul 24, 2017 in forum: Troubleshooting
  5. Gomo2017
    Post

    Solved Build platform on my R1 stopped heating.

    I looked at the green plug and it has no sign of being burnt, also no other components look burnt. Not ruling that possibility out, thanks for...
    Post by: Gomo2017, Jul 23, 2017 in forum: Troubleshooting
  6. Gomo2017
    Thread

    Solved Build platform on my R1 stopped heating.

    I have been building ABS parts very nicely for three months and have just now switched to PLA. On my third PLA part the print bed stopped heating...
    Thread by: Gomo2017, Jul 22, 2017, 11 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again