1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Momenslythe
    Thread

    Benchy overhang issue

    I am having an issue with the overhang in the front of my benchy on my R2. I'm not sure what causes this issue. Both of these are using the same...
    Thread by: Momenslythe, Sep 17, 2018, 3 replies, in forum: Troubleshooting
  2. Momenslythe
    Thread

    Temp Tower Results

    I want to do a couple things with this post. First, I would like to share my results on a temperature tower for my R2 in a variety of...
    Thread by: Momenslythe, Sep 13, 2018, 0 replies, in forum: Troubleshooting
  3. Momenslythe
    Thread

    Solved Printer stays put at end of print making bad top layer

    My C2 (and my R2) sit in place at the end of a print and ends up making a dimple/nipple in that spot on my prints. How can I get the extruder to...
    Thread by: Momenslythe, Sep 12, 2017, 24 replies, in forum: Troubleshooting
  4. Momenslythe
    Thread

    Squeaking Issues and Bed Adhesion

    My printer makes a horrible squeaking noise when I print. This will either happen later in prints that are small such as 3DBenchy or when the head...
    Thread by: Momenslythe, Sep 1, 2017, 11 replies, in forum: Troubleshooting
  5. Momenslythe
    Thread

    Bubbly boat issue

    I'm having trouble with this bubbliness on my ABS print. I used the Low Quality setting for this one and am printing one with the High Quality...
    Thread by: Momenslythe, Aug 31, 2017, 22 replies, in forum: Troubleshooting
  6. Momenslythe
    Thread

    Partial Answer Why does my ditto have stretch marks?

    I'm getting this mark on every ditto I print regardless of print quality setting. I'm not sure why. the mark is more intense when printing at High...
    Thread by: Momenslythe, Aug 30, 2017, 21 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again