1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. jscottb
    Thread

    Quiet fan recomendations for the R2

    I really would like to replace the fans, especially the 20mm hotend cooler fan. It howls like the wind in an old horror movie. I have other...
    Thread by: jscottb, Feb 21, 2020, 5 replies, in forum: General Questions
  2. jscottb
    Thread

    What print speed are you printing at most of the time?

    This is for plain ole PLA and medium quality prints. I have printed as fast as 68mm a sec and the temp at 206c with goodish results. Most of the...
    Thread by: jscottb, Nov 14, 2017, 6 replies, in forum: General Questions
  3. jscottb
    Thread

    Filament run out lcd screen.

    I have had the Filament run out lcd plug-in screen to lock up twice now. Out of 4 times of running out of finament, it's do this. Octo still...
    Thread by: jscottb, Nov 14, 2017, 2 replies, in forum: Software
  4. jscottb
    Thread

    Pogo No-go after couple of months :(

    Well, it finally happened today 2hrs into a 10hr print. The pogo pins gave way :( On the bed negative side so far. Print stopped after it could...
    Thread by: jscottb, Nov 12, 2017, 8 replies, in forum: Troubleshooting
  5. jscottb
    Thread

    R2 Bed is kind of fiddly...

    Hello, I have had my R2 for a few weeks now and really like it a lot. It prints great. But... The bed needs leveling just about every print. I...
    Thread by: jscottb, Oct 18, 2017, 16 replies, in forum: Troubleshooting
  6. jscottb
    Thread

    Z-screw stabilizer plug

    I hate wobbly rods :) So here is a simple plug to keep the z screw from wobbling. If you print it, let me know of any issues....
    Thread by: jscottb, Sep 16, 2017, 5 replies, in forum: Mods and Upgrades
  7. jscottb
    Thread

    The rpi password for user pi is still set to the default

    I would look to changing this to something else. I would hope it's not used anywhere in the Robo3d addons or mods for Octoprint. Just an FYI...
    Thread by: jscottb, Sep 15, 2017, 6 replies, in forum: Software
  8. jscottb
    Thread

    R2 received and in production!

    I have my new R2 and it came in good condition. There was only one small issue... The boxes inside pressed against the X stepper connection and...
    Thread by: jscottb, Sep 15, 2017, 26 replies, in forum: Show and Tell
Showing results 1 to 8 of 8
Search Again