1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. RokleM
    Post

    Unresolved Sudden infill issues?

    Ambient temp has increased 4 degrees in the room. Again, I don't understand the continuous comments at the slicer after explaining (don't take it...
    Post by: RokleM, May 3, 2016 in forum: Troubleshooting
  2. RokleM
    Post

    Unresolved Sudden infill issues?

    So I assumed this would be an easier answer, but apparently not. Let me clarify. "same filament, same settings, same SLT"... My point is this is...
    Post by: RokleM, May 3, 2016 in forum: Troubleshooting
  3. RokleM
    Post

    Unresolved Sudden infill issues?

    no...
    Post by: RokleM, May 2, 2016 in forum: Troubleshooting
  4. RokleM
    Thread

    Unresolved Sudden infill issues?

    Confused by this one. Same setup as previously (same filament, same settings, same SLT), all the sudden my prints have a gap on the borders....
    Thread by: RokleM, May 2, 2016, 11 replies, in forum: Troubleshooting
  5. RokleM
    Post

    Solved Leveling, goes to right and grinds

    Found it finally! On probably my 4th check through, I found one of the left wires was literally hanging on by a thread. It must have not been...
    Post by: RokleM, Apr 18, 2016 in forum: Troubleshooting
  6. RokleM
    Thread

    Solved Leveling, goes to right and grinds

    All, I've done some searching and not really finding answers. The printer was working fine, and all the sudden fails to function. Basically the...
    Thread by: RokleM, Apr 18, 2016, 3 replies, in forum: Troubleshooting
  7. RokleM
    Post

    Solved Sealing extruder/heating element?

    Assembling while hot did indeed fix the issue, thanks.
    Post by: RokleM, Mar 18, 2016 in forum: Troubleshooting
  8. RokleM
    Post

    Solved Sealing extruder/heating element?

    Actually Robo3d recommended using high temp sealant. I have a good 4.5mm wrench and am grabbing the hot end with a pair of vice grips to the...
    Post by: RokleM, Mar 14, 2016 in forum: Troubleshooting
  9. RokleM
    Thread

    Solved Sealing extruder/heating element?

    All, got my robo3d out of storage as it's been a while and have time to mess with it again. I had a few prints go well, then started having major...
    Thread by: RokleM, Mar 14, 2016, 5 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again