1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Braxton Piwonka
    Post

    R2 Stuck after reflashing SD card

    Etcher is the one I’ve been using because it was directly referred by the Robo tech that gave me the image:/ I came across a thread about...
    Post by: Braxton Piwonka, Jan 12, 2019 in forum: Troubleshooting
  2. Braxton Piwonka
    Post

    R2 Stuck after reflashing SD card

    Oh, but not hours?! Then I’m out of luck,, because I loaded robots new image on a brand new sd & it’s been stuck for over an hour again
    Post by: Braxton Piwonka, Jan 12, 2019 in forum: Troubleshooting
  3. Braxton Piwonka
    Post

    R2 Stuck after reflashing SD card

    Do you have any idea how long the reflash typically takes? Even a rough estimate?
    Post by: Braxton Piwonka, Jan 12, 2019 in forum: Troubleshooting
  4. Braxton Piwonka
    Post

    R2 Stuck after reflashing SD card

    I’m afraid I don’t have the original:/ Straight up noob move, I now realize! I was sure to copy a version of the new one Robo sent me this time.....
    Post by: Braxton Piwonka, Jan 12, 2019 in forum: Troubleshooting
  5. Braxton Piwonka
    Post

    R2 Stuck after reflashing SD card

    Oh.. & this is the second new sd card I’ve attempted it on..
    Post by: Braxton Piwonka, Jan 12, 2019 in forum: Troubleshooting
  6. Braxton Piwonka
    Thread

    R2 Stuck after reflashing SD card

    Hey guys, sorry to add onto this & also if what I’m looking for is somewhere else in the forum.. if it I missed it, it’s not from lack of...
    Thread by: Braxton Piwonka, Jan 12, 2019, 10 replies, in forum: Troubleshooting
  7. Braxton Piwonka
    Post

    Success?? with NinjaFlex or other flexible

    Dang sorry for leaving you hanging! I didn't have my notifications turned on for some reason... For what it's worth & if it's not too late; Yes,...
    Post by: Braxton Piwonka, Mar 13, 2018 in forum: General Questions
  8. Braxton Piwonka
    Post

    Success?? with NinjaFlex or other flexible

    I guess that tiny space between the feed hole below the bolt and tension spring didn't quite peak high enough between them to keep the "ninjaflop"...
    Post by: Braxton Piwonka, Jan 20, 2018 in forum: General Questions
  9. Braxton Piwonka
    Post

    Success?? with NinjaFlex or other flexible

    Thanks for the responses.. I already did the tube mod.. even though there is very little room and seeming need for it, but with ninjaflex, before...
    Post by: Braxton Piwonka, Jan 20, 2018 in forum: General Questions
  10. Braxton Piwonka
    Post

    Success?? with NinjaFlex or other flexible

    Hey guys, quick question for anyone willing to help out a beginner.. I had a nightmare overnight PLA disaster clog that required some serious...
    Post by: Braxton Piwonka, Jan 20, 2018 in forum: General Questions
Showing results 1 to 10 of 10
Search Again