1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Danfan
    Thread

    Recent Project – Pose-able Robot Action Figure!

    When I was going to college in the 70s, I started sketching a simple cartoon robot figure in the margins of my class notebooks when I got bored in...
    Thread by: Danfan, Aug 7, 2020, 0 replies, in forum: Show and Tell
  2. Danfan
    Post

    Anyone feel like sharing some pics!!

    This is my first time to try posting a photo. Hope I get this right... Here is my setup. The I did have my printer set up on an old paper printer...
    Post by: Danfan, Aug 7, 2020 in forum: Show and Tell
  3. Danfan
    Post

    Solved Suggestions for printing with damaged print bed

    I found a 10" x 12" x 3/32" pre-cut sheet of glass at Home Depot that would cover the print area (so I could skip the cutting and buffing of the...
    Post by: Danfan, Aug 6, 2020 in forum: General Questions
  4. Danfan
    Post

    Solved Suggestions for printing with damaged print bed

    Thanks for the help! I’ll make a Home Depot run tomorrow, cut it down, and try it out.
    Post by: Danfan, Aug 5, 2020 in forum: General Questions
  5. Danfan
    Post

    Solved Suggestions for printing with damaged print bed

    Thanks for the suggestion! It seems like a simple solution that maintains a heated bed. By float glass I assume that includes the stock stuff...
    Post by: Danfan, Aug 5, 2020 in forum: General Questions
  6. Danfan
    Thread

    Solved Suggestions for printing with damaged print bed

    I would like some suggestions from you guys about a problem that has bitten me. I’ve been printing for 2 ½ years on my Robo 3D 1+ and disaster has...
    Thread by: Danfan, Aug 5, 2020, 5 replies, in forum: General Questions
Showing results 1 to 6 of 6
Search Again