1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. BenJoeM
    Thread

    Z-offset issue or slicer

    i am slicing using CURA 2.5 the generic version that comes with the C2. recently when I send a file to print sliced via CURA either through the...
    Thread by: BenJoeM, May 28, 2022, 6 replies, in forum: Troubleshooting
  2. BenJoeM
    Thread

    Z Off Set and Delay in Retraction of Extruder at the end

    Hey, I have had my C2 for sometime and for some reason in the past few months I seem to struggle to get my Z OFF set correct. I do all the...
    Thread by: BenJoeM, Aug 1, 2020, 5 replies, in forum: Troubleshooting
  3. BenJoeM
    Thread

    Solved Robo c2 extruder problem

    Hey. Sudden issue. I’ve been printing just fine for weeks when suddenly my latest print the extruder on the right side wants to lift higher than...
    Thread by: BenJoeM, Jun 2, 2020, 3 replies, in forum: Troubleshooting
  4. BenJoeM
    Thread

    Feed Gear works perfectly with Robo C2 Files only

    So looking for some help here. I have now tested 4 filaments and 4 different prints off of the USB drive with. my C2 without issue. But as soon...
    Thread by: BenJoeM, Jun 15, 2018, 2 replies, in forum: Troubleshooting
  5. BenJoeM
    Thread

    Solved New C2 - Connection Interrupted error and New Image won't work!

    New C2 arrived this week as a warranty replacement. Fired it up and it is said "connection interrupted error". So I followed the troubleshooting...
    Thread by: BenJoeM, May 25, 2018, 32 replies, in forum: Troubleshooting
  6. BenJoeM
    Thread

    Bed Grinding as it lowers - Z-Axis End Stop works manually

    So Tech support continues to treat me like I am a moron so I am coming back to the forum for help. The C2 has been nothing but a nightmare for me...
    Thread by: BenJoeM, May 4, 2018, 12 replies, in forum: Troubleshooting
  7. BenJoeM
    Thread

    Help Installing New Ribbon Cable for Monitor

    Robo sent me a new ribbon cable to connect from the Rasberry Pi to the Monitor but I need to remove the back cover it appears to connect a power...
    Thread by: BenJoeM, Feb 12, 2018, 26 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again