1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Angel C
    Post

    Community Favorite Mike Kelly's RoBo3D Enclosure

    [IMG][IMG][IMG][IMG][IMG][IMG][IMG] So I able to finish my enclosure in a day but had few problem along the way but I guess that happen...
    Post by: Angel C, May 5, 2019 in forum: Mods and Upgrades
  2. Angel C
    Post

    Community Favorite Mike Kelly's RoBo3D Enclosure

    So guys I got my kit from printedsolid along with a e3dv6 and will start install tomorrow. I’ll post my progress wish me luck!! Sent from my...
    Post by: Angel C, May 1, 2019 in forum: Mods and Upgrades
  3. Angel C
    Post

    Answered Z axis offset for pei sheet

    Hey Geof I had use the start up code that you had mention in that post but I’m still having problem when it home and wait for nozzle to heat up as...
    Post by: Angel C, Aug 10, 2018 in forum: Troubleshooting
  4. Angel C
    Thread

    Answered Z axis offset for pei sheet

    Hey guy I installed pei sheet a month or so back and Im have a problem with the offset for the sheet. When I home the nozzle it touching the bed....
    Thread by: Angel C, Aug 2, 2018, 4 replies, in forum: Troubleshooting
  5. Angel C
    Post

    PEI Sheets precut with 3m

    Thank Geof I’m work on the g code tonight also thanks for the offer on helping me with assemble mike box looking forward to it Sent from my...
    Post by: Angel C, Jun 23, 2018 in forum: Mods and Upgrades
  6. Angel C
    Post

    PEI Sheets precut with 3m

    Hey guys just got my package from @Printed Solid as they were have a sell for David’s birthday. I end up get e3d extruder, mike Kelly box (a lil...
    Post by: Angel C, Jun 21, 2018 in forum: Mods and Upgrades
  7. Angel C
    Post

    Answered Substance use for the wire under the heat bed

    Thanks again mark having ppl like you on this forums really help out with newbies like me to gain better Knowledge Sent from my iPhone using...
    Post by: Angel C, Jun 10, 2018 in forum: Troubleshooting
  8. Angel C
    Post

    Answered Substance use for the wire under the heat bed

    Thanks hoa and mark for the feedback, once I realize what the camera mount did. I did take it off until I figure what am i going to I have been...
    Post by: Angel C, Jun 10, 2018 in forum: Troubleshooting
  9. Angel C
    Thread

    Answered Substance use for the wire under the heat bed

    Hey guys my name is Angel I’ve been on the forum for a lil while only to browsing for answer and idea for my Robo3d R1 not the plus. I looking to...
    Thread by: Angel C, Jun 7, 2018, 6 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again