1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. trevely
    Thread

    Bearings Problem

    Hi all, Once again I'm having issues with my Robo R2. Awhile back I was having a problem with prints shifting and it turned out to be one of the...
    Thread by: trevely, Nov 17, 2018, 20 replies, in forum: Troubleshooting
  2. trevely
    Thread

    Major Printing Problems

    Hi all, Any help/guidance, anything will be appreciated if you can help me figure out what is going on with my printer or my prints. I recently...
    Thread by: trevely, Oct 23, 2018, 10 replies, in forum: Troubleshooting
  3. trevely
    Thread

    Starting to get frustrated

    Hi all, I'm not sure what is going on but lately I've been having problems with my prints ruining the sheet on the bed when trying to get the...
    Thread by: trevely, Aug 5, 2018, 21 replies, in forum: Troubleshooting
  4. trevely
    Thread

    Print Problem

    I hope I have this in the right place if not my apologies, please move it. I have the Robo R2 and I'm using S3D and getting this problem on my...
    Thread by: trevely, Jun 8, 2018, 4 replies, in forum: Troubleshooting
  5. trevely
    Thread

    Clicking sound

    Hey all, I've had the Robo R2 for about a week now and enjoying it so far. Have a question though, what could be causing this loud clicking when...
    Thread by: trevely, May 16, 2018, 4 replies, in forum: Troubleshooting
  6. trevely
    Thread

    Greetings from the PNW

    Hi all, Tyrone here and I just purchased a Robo R2 and waiting for it to get delivered (always the hardest part). I did a lot of research on this...
    Thread by: trevely, May 4, 2018, 7 replies, in forum: United States of America
Showing results 1 to 6 of 6
Search Again