1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. elmoret
    Post

    Solved Filament Extruder

    Tim here, from Filastruder. Holding tolerances isn't as difficult as some may think. Big production lines struggle with it more than a...
    Post by: elmoret, Dec 16, 2016 in forum: General Questions
  2. elmoret
    Post

    Solved Z layers not stacking nicely, vibrations in the print along X and Y

    Some people report slight changes in print quality, usually positive. The benefit is mostly noise. though. That line is not rooted in reality....
    Post by: elmoret, Dec 16, 2016 in forum: Troubleshooting
  3. elmoret
    Post

    Solved Z layers not stacking nicely, vibrations in the print along X and Y

    They definitely make things quieter. They're cheaper at Filastruder and Ultibots, if you're interested.
    Post by: elmoret, Dec 16, 2016 in forum: Troubleshooting
  4. elmoret
    Post

    E3D Titan Extruder

    We're mirroring that code at Filastruder. In general, all E3D coupon codes are mirrored at Filastruder.
    Post by: elmoret, Apr 11, 2016 in forum: Mods and Upgrades
  5. elmoret
    Post

    E3D Titan Extruder

    46.3mm wide, 25.2mm deep, 43.8mm tall not counting the protrusion for the tensioning spring or the idler arm.
    Post by: elmoret, Apr 9, 2016 in forum: Mods and Upgrades
  6. elmoret
    Post

    E3D Titan Extruder

    I'm not sure, I just see it marked as completed on the super secret beta tester Google doc.
    Post by: elmoret, Apr 9, 2016 in forum: Mods and Upgrades
  7. elmoret
    Post

    E3D Titan Extruder

    No, you can use lower torque NEMA17s. BigBox uses a 42BYGHM809 for the non-geared extruder, which has a holding torque of 48 Ncm and a mass of...
    Post by: elmoret, Apr 9, 2016 in forum: Mods and Upgrades
  8. elmoret
    Post

    E3D Titan Extruder

    A writeup/guide/parts are already complete for the Robo3D, E3D is in the process of reformatting it for their wiki. Just didn't want folks to...
    Post by: elmoret, Apr 9, 2016 in forum: Mods and Upgrades
Showing results 1 to 8 of 8
Search Again