1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Thanks for the suggestion! I have a physical disability that effects my fine muscle control so there's no way I could do that! And the people who...
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  2. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Thanks everyone for all the help! I think I'm down to it being a problem with my board. My LEDs and fan for cooling the layers are now dead too....
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  3. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Could my board in my printer be messed up even though I'm not getting an error?
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  4. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    ->M503 <-echo:Steps per unit: <-echo: M92 X80.00 Y80.00 Z800.00 E723.38 <-echo:Maximum feedrates (mm/s): <-echo: M203 X500.00 Y500.00 Z5.00...
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  5. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Do you mean under Options -> EEProm? Interesting, yesterday was the first time I looked in there and it came up but now when I try to get in there...
    Post by: Brad Whitmoyer, Dec 19, 2018 in forum: Troubleshooting
  6. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Okay so when I did the G28, instead of the extruder going to the left all the way, it went to the right all the way. In MatterControls, you have...
    Post by: Brad Whitmoyer, Dec 18, 2018 in forum: Troubleshooting
  7. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Do you mean just turning it off at the switch? I've done that.
    Post by: Brad Whitmoyer, Dec 18, 2018 in forum: Troubleshooting
  8. Brad Whitmoyer
    Post

    Partial Answer movements and speed doubled

    Nope
    Post by: Brad Whitmoyer, Dec 18, 2018 in forum: Troubleshooting
  9. Brad Whitmoyer
    Thread

    Partial Answer movements and speed doubled

    Hello all, hoping someone can help. I have a robo 3D R1+ and using MatterControls. All of a sudden all of the movements and speeds of the printer...
    Thread by: Brad Whitmoyer, Dec 18, 2018, 19 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again