1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. RickoT
    Post

    Unresolved Robo 3D R1+ - Simply unable to calibrate extruder

    Ok, So on a whim I decided to disable EEPROM and stop using Octoprint to configure this and use matter control instead. I also decided to go...
    Post by: RickoT, May 20, 2021 in forum: Troubleshooting
  2. RickoT
    Post

    Unresolved Robo 3D R1+ - Simply unable to calibrate extruder

    Ahhhhh, ok that makes sense. Let me do that then, will report back :D
    Post by: RickoT, May 20, 2021 in forum: Troubleshooting
  3. RickoT
    Post

    Unresolved Robo 3D R1+ - Simply unable to calibrate extruder

    I updated it in the firmware and flashed it, do I need to power cycle the printer for it to take? I was under the impression when you flash with...
    Post by: RickoT, May 20, 2021 in forum: Troubleshooting
  4. RickoT
    Post

    Unresolved Robo 3D R1+ - Simply unable to calibrate extruder

    ok, so I went ahead and did a few calibrations/measurements starting at 723.38 .. it extruded 46.6 Per the formula... 100/46.6 = 2.2421 2.242 x...
    Post by: RickoT, May 20, 2021 in forum: Troubleshooting
  5. RickoT
    Post

    Unresolved Robo 3D R1+ - Simply unable to calibrate extruder

    Thanks! Sorry I missed that line... I will see what I get out of this thing today, hoping to get closer :)
    Post by: RickoT, May 20, 2021 in forum: Troubleshooting
  6. RickoT
    Post

    Unresolved Robo 3D R1+ - Simply unable to calibrate extruder

    This is what mine says #define DEFAULT_AXIS_STEPS_PER_UNIT {80,80,800,723.38} // default steps per unit for RoBo 3D R1 Should I change it to...
    Post by: RickoT, May 20, 2021 in forum: Troubleshooting
  7. RickoT
    Post

    Unresolved Robo 3D R1+ - Simply unable to calibrate extruder

    Hey Mark, Thanks for the info. I am reloading the ROBO3DR1PLUSV2 firmware (It's the only firmware I could find). I have also enabled the...
    Post by: RickoT, May 19, 2021 in forum: Troubleshooting
  8. RickoT
    Thread

    Unresolved Robo 3D R1+ - Simply unable to calibrate extruder

    Greetings, This is my first time around these parts (in the world of 3d printing and this device) I figured the first thing I should probably do...
    Thread by: RickoT, May 19, 2021, 16 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again