1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    Finally back, i had a closer look on the broken board and the problem is just a burnt transistor.. i will replace it in a couple of weeks when the...
    Post by: JohnTheQniqueGuy, Jun 30, 2019 in forum: Troubleshooting
  2. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    gonna buy a new one then :D
    Post by: JohnTheQniqueGuy, Apr 8, 2019 in forum: Troubleshooting
  3. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    Both fans are on 100%..
    Post by: JohnTheQniqueGuy, Apr 8, 2019 in forum: Troubleshooting
  4. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    Is the RAMPS board broken then? Edit: There is another fan port on the board.. it's for a fan in the case.. When i connect it to that...
    Post by: JohnTheQniqueGuy, Apr 8, 2019 in forum: Troubleshooting
  5. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    wires were not the problem :/ The voltage drops when i connect the fan.
    Post by: JohnTheQniqueGuy, Apr 8, 2019 in forum: Troubleshooting
  6. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    That was not the faulty part of wire! OMG.. hmmm I might have a bigger problem.
    Post by: JohnTheQniqueGuy, Apr 8, 2019 in forum: Troubleshooting
  7. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    Wires are not cooperating with me today :/
    Post by: JohnTheQniqueGuy, Apr 8, 2019 in forum: Troubleshooting
  8. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    umm I measured the voltage on the board and it is exactly 12V.. The cable must be bad because if i measure it near the fan it's not 12V :/ Time...
    Post by: JohnTheQniqueGuy, Apr 8, 2019 in forum: Troubleshooting
  9. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    I will look into the printer.. give me a minute
    Post by: JohnTheQniqueGuy, Apr 8, 2019 in forum: Troubleshooting
  10. JohnTheQniqueGuy
    Post

    Answered Parts fan not working properly.

    It is a 12V fan and it spins in the right direction..
    Post by: JohnTheQniqueGuy, Apr 8, 2019 in forum: Troubleshooting
  11. JohnTheQniqueGuy
    Thread

    Answered Parts fan not working properly.

    Hello, I am pretty new to 3d printers so the solution might be obvious. I needed to replace my parts fan because I broke it when replacing the...
    Thread by: JohnTheQniqueGuy, Apr 8, 2019, 19 replies, in forum: Troubleshooting
Showing results 1 to 11 of 11
Search Again