1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. dylantep
    Post

    Community Favorite Bed Heater - Installing SSR & PID Control Instructions

    Hello all, I recently got an abandoned robo 3d r1. It looks like the previous owner installed an SSR. I am having trouble getting the bed to heat...
    Post by: dylantep, Aug 29, 2019 in forum: Mods and Upgrades
  2. dylantep
    Post

    Answered Was recently given an R1. Bed wont heat.

    ok, so, there was another bed floating around in all the stuff I received with the printer. This one is the newer style with magnets. I had to...
    Post by: dylantep, Aug 29, 2019 in forum: Troubleshooting
  3. dylantep
    Post

    Answered Was recently given an R1. Bed wont heat.

    ok. I think I was checking the wrong side of the SSR. looks like both sides read 12v. Wires are looking good to me. I can't really see under the...
    Post by: dylantep, Aug 29, 2019 in forum: Troubleshooting
  4. dylantep
    Post

    Answered Was recently given an R1. Bed wont heat.

    Thank you so much for helping I'm measuring 12v on both D8 on the RAMPS board and on the SSR output. So I guess I need to replace the SSR?
    Post by: dylantep, Aug 29, 2019 in forum: Troubleshooting
  5. dylantep
    Post

    Answered Was recently given an R1. Bed wont heat.

    Thanks for help and helpful links. The heat sink is attached to an SSR. Is there a way to tell if the issue is with the SSR or the RAMPS board?
    Post by: dylantep, Aug 29, 2019 in forum: Troubleshooting
  6. dylantep
    Post

    Answered Was recently given an R1. Bed wont heat.

    Thanks, I hadnt seen the terminal in the upper left (above the green circle) or the large heat sink in the top center on anyone else printer. I...
    Post by: dylantep, Aug 29, 2019 in forum: Troubleshooting
  7. dylantep
    Post

    Answered Was recently given an R1. Bed wont heat.

    http://imgur.com/a/izW0ENN
    Post by: dylantep, Aug 29, 2019 in forum: Troubleshooting
  8. dylantep
    Post

    Answered Was recently given an R1. Bed wont heat.

    Looks like I need 3 posts to be able to add links
    Post by: dylantep, Aug 29, 2019 in forum: Troubleshooting
  9. dylantep
    Post

    Answered Was recently given an R1. Bed wont heat.

    Thanks! I've been trying to sort out the pictures. I'll try imgur
    Post by: dylantep, Aug 29, 2019 in forum: Troubleshooting
  10. dylantep
    Thread

    Answered Was recently given an R1. Bed wont heat.

    Hello everyone, I was recently given someones old R1 printer. It looks like they did some modifications and I'm not fimilar enough with the...
    Thread by: dylantep, Aug 29, 2019, 19 replies, in forum: Troubleshooting
Showing results 1 to 10 of 10
Search Again