1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. VigilantWookie
    Thread

    Filament Status: Filament Has Run Out

    I keep getting this message when trying to run a print. There is still filament on the spool, and it is feeding into the hotend, but eventually,...
    Thread by: VigilantWookie, Apr 14, 2022, 1 replies, in forum: Troubleshooting
  2. VigilantWookie
    Thread

    Cura for R2 not opening

    I just upgraded my computer, and after installing Cura for R2, it won't open. It starts like it will, showing the logo and saying it's loading,...
    Thread by: VigilantWookie, Feb 3, 2021, 3 replies, in forum: Troubleshooting
  3. VigilantWookie
    Thread

    Cutting STL files

    So I'm trying to cut/slice an STL file that I have that is too large to fit on the print surface. I'm using Fusion 360 to do so. I sliced the...
    Thread by: VigilantWookie, Sep 23, 2020, 3 replies, in forum: General Questions
  4. VigilantWookie
    Thread

    Print Stuck

    My finished print is stuck on the print bed and I haven't been able to remove it yet. Suggestions?
    Thread by: VigilantWookie, Feb 21, 2020, 2 replies, in forum: Troubleshooting
  5. VigilantWookie
    Thread

    Bed Leveling

    Running through the bed leveling wizard, and when I get to the back two screws on the print bed, and cannot get the print surface even remotely...
    Thread by: VigilantWookie, Feb 14, 2020, 3 replies, in forum: Troubleshooting
  6. VigilantWookie
    Thread

    Touchscreen Issue

    I got my printer this week. I ran a test print right out of the box and had not issues (other than slight calibration adjustments). I finally go...
    Thread by: VigilantWookie, Feb 7, 2020, 3 replies, in forum: Troubleshooting
  7. VigilantWookie
    Thread

    Touchscreen Issue

    I just got the printer this week. I got it hooked up to wi-fi finally, and uploaded the most recent update. I'd run a test print prior, and had...
    Thread by: VigilantWookie, Feb 7, 2020, 3 replies, in forum: Troubleshooting
  8. VigilantWookie
    Thread

    New Owner-Print Edges curling early in print

    Just got my R2 the other day. When I'm running prints, the edges/corners are curling up. Using the spool of PLA that came with the printer. Bed...
    Thread by: VigilantWookie, Feb 6, 2020, 6 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again