1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Louis Hall
    Post

    Robo R2 Z Wizard wont calibrate correctly

    I’m an educator so can purchase S3D for about $100. Have heard it’s pretty much the best. If there is a free one on par I would check it out.
    Post by: Louis Hall, Apr 19, 2020 in forum: Troubleshooting
  2. Louis Hall
    Post

    Robo R2 Z Wizard wont calibrate correctly

    Thanks! Yea, the R1 is pretty fantastic when tuned up correctly. I’ve been stuck on mattercontrol, any suggestions for a better slicer that works...
    Post by: Louis Hall, Apr 19, 2020 in forum: Troubleshooting
  3. Louis Hall
    Post

    Robo R2 Z Wizard wont calibrate correctly

    Thank you! It took me roughly 48 hours of messing around with this darned machine to figure out some of these unclear nuances. I rolled the...
    Post by: Louis Hall, Apr 19, 2020 in forum: Troubleshooting
  4. Louis Hall
    Post

    Robo R2 Z Wizard wont calibrate correctly

    Hey Mark, Thanks for your reply! Do you have an R2?
    Post by: Louis Hall, Apr 17, 2020 in forum: Troubleshooting
  5. Louis Hall
    Post

    Robo R2 Z Wizard wont calibrate correctly

    I purchased an R2 and it was delivered the other day. The past two days have been awful. I have 4x Robo3D R1+ printers and although they are...
    Post by: Louis Hall, Apr 17, 2020 in forum: Troubleshooting
  6. Louis Hall
    Post

    Robo R2 Printing in Air

    Thank you Mark!
    Post by: Louis Hall, Apr 17, 2020 in forum: Troubleshooting
  7. Louis Hall
    Thread

    Robo R2 Printing in Air

    Hi All, I own 3x Robo3D R1+ units and love Mattercontrol. I have been printing face shields for Covid19 for EMS on a small island that I live on...
    Thread by: Louis Hall, Apr 16, 2020, 6 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again