1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Terminal
    Post

    R2/C2 Linear Rail Bracket Ends

    Is there a tutorial on how to replace these easily ?
    Post by: Terminal, Apr 18, 2020 in forum: Projects
  2. Terminal
    Post

    Calibrated Bed and Z Offset, weird clicking no prints

    So, I've switched between 3 different filaments, and it appears it is that filament specifically, all my other filaments print perfectly. I also...
    Post by: Terminal, Apr 8, 2020 in forum: Troubleshooting
  3. Terminal
    Post

    How to adjust print speed?

    Thanks! I’ve started doing this where is the FAQ ?
    Post by: Terminal, Apr 7, 2020 in forum: General Questions
  4. Terminal
    Post

    Calibrated Bed and Z Offset, weird clicking no prints

    I've run through the leveling guide at the top of this section and it resulted in the same results. I've now fully changed out my filament and to...
    Post by: Terminal, Apr 7, 2020 in forum: Troubleshooting
  5. Terminal
    Thread

    Calibrated Bed and Z Offset, weird clicking no prints

    When I do a calibration, I get perfect lines and circles, the I try to print a model (previously printed before) and I get horrible results and a...
    Thread by: Terminal, Apr 7, 2020, 5 replies, in forum: Troubleshooting
  6. Terminal
    Post

    How to adjust print speed?

    I've been uploading the STL file via the Web then going over to the Robo and slicing there. I am using the CuraEngine Slicer
    Post by: Terminal, Apr 7, 2020 in forum: General Questions
  7. Terminal
    Thread

    How to adjust print speed?

    I have a stock Robo R2, how can I adjust the print speed? I don't see settings in the web UI for that
    Thread by: Terminal, Apr 7, 2020, 7 replies, in forum: General Questions
Showing results 1 to 7 of 7
Search Again