1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. SC_MudDuck
    Post

    Top Enclosure

    The only loss volume is in the Z. Been searching the thingiverse, but haven't seen any solutions yet. I like your description, but need to do a...
    Post by: SC_MudDuck, Dec 8, 2021 in forum: General Questions
  2. SC_MudDuck
    Post

    Top Enclosure

    How do you compensate for Z wobble? Do you have a pic posted that I check out? I'm still running factory Z setup...
    Post by: SC_MudDuck, Dec 8, 2021 in forum: General Questions
  3. SC_MudDuck
    Post

    Solved Robo3D R1+ Clogs

    Thank you for the responses. Turns out the hotend cooling fan crapped out and required replacement, so problem solved.
    Post by: SC_MudDuck, Dec 8, 2021 in forum: Troubleshooting
  4. SC_MudDuck
    Thread

    Top Enclosure

    I will say I hate with a passion the top enclosure. It is cumbersome to work around at times and I lose 20-30 mm of build volume. Does anyone...
    Thread by: SC_MudDuck, Nov 19, 2021, 5 replies, in forum: General Questions
  5. SC_MudDuck
    Thread

    Solved Robo3D R1+ Clogs

    Having issues with clogs. Followed the normal hot end drop and clear, followed by several cold pulls (250/135), and have cleaned the hobbed bolt...
    Thread by: SC_MudDuck, Nov 19, 2021, 3 replies, in forum: Troubleshooting
  6. SC_MudDuck
    Post

    Unanswered why do none of my PID values match after 7 successive iterations

    Replaced the heater cartridge to 40W, still waiting on the thermistor. I have observed where it still has a difficult time overcoming the fans @...
    Post by: SC_MudDuck, Apr 5, 2021 in forum: Troubleshooting
  7. SC_MudDuck
    Post

    Unanswered why do none of my PID values match after 7 successive iterations

    Thanks for the reply Mark, it was very helpful. I will search for the necessary parts for the repair/upgrade. Should I see similar values upon...
    Post by: SC_MudDuck, Mar 31, 2021 in forum: Troubleshooting
  8. SC_MudDuck
    Post

    Unanswered why do none of my PID values match after 7 successive iterations

    So does no one know what I am asking? Help me help you understand my question. If no one can help, is there anywhere else I can look for this...
    Post by: SC_MudDuck, Mar 30, 2021 in forum: Troubleshooting
  9. SC_MudDuck
    Thread

    Unanswered why do none of my PID values match after 7 successive iterations

    Trying to solve my dreaded E1 Thermal Runaway issue by doing a PID Tune. After running the tune 7 back to back times, I do not see any...
    Thread by: SC_MudDuck, Mar 29, 2021, 7 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again