1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Lasse Knudsen
    Thread

    Partial Answer Filament hard to push through extruder

    Greetings, I have several robo3D printers, however one of them has an issue with "normal" PLA, in that it will always gnaw into it so it cannot...
    Thread by: Lasse Knudsen, Feb 12, 2018, 2 replies, in forum: Troubleshooting
  2. Lasse Knudsen
    Thread

    Solved Weird behavior from extruder stepper motor

    Greetings, I have some trouble with the extruder stepper on my printer, it has begun behaving oddly. It looks like its being asked to step, but...
    Thread by: Lasse Knudsen, Dec 19, 2016, 2 replies, in forum: Troubleshooting
  3. Lasse Knudsen
    Thread

    Solved Z axis "long hex nuts" showing

    Greetings, i had a print that was righer than i realized, and now the two brass hex nuts are showing, and zstop no longer works. How do i go...
    Thread by: Lasse Knudsen, Dec 7, 2016, 4 replies, in forum: Troubleshooting
  4. Lasse Knudsen
    Thread

    Solved Problems with "Pitting" in top layers

    Greetings, i see issues with pitting when i print with few top layers, the picture shows a print printed at 0.1 mm layer height, 25% infill, With...
    Thread by: Lasse Knudsen, Oct 20, 2016, 9 replies, in forum: Troubleshooting
  5. Lasse Knudsen
    Thread

    Unresolved Robo3D Layer issue while printing.

    Greetings, I did two things to improve the situation, first one was really silly on my part. turned out that the heated bed was touching the wall,...
    Thread by: Lasse Knudsen, Aug 23, 2016, 1 replies, in forum: Troubleshooting
  6. Lasse Knudsen
    Thread

    Solved Robo3D 24/7 support phone

    Greetings, Is there something wrong with the 24/7 support site, i have called maybe 10 times at different times of the day, and when im not...
    Thread by: Lasse Knudsen, Aug 22, 2016, 19 replies, in forum: Troubleshooting
  7. Lasse Knudsen
    Thread

    Unresolved Y axis off skipping in the middle of the print

    Greetings, i have noticed that my printer, ontop of the filament feeding problem, is "offsetting" on the Y axis, this thing should be a be...
    Thread by: Lasse Knudsen, Aug 16, 2016, 1 replies, in forum: Troubleshooting
  8. Lasse Knudsen
    Thread

    Partial Answer Jagging on filament

    Greetings, Im sitting here with my 1 week old Robo3D, this is my 4th of these printers, and in now experincing something i have not seen before....
    Thread by: Lasse Knudsen, Aug 12, 2016, 6 replies, in forum: Troubleshooting
  9. Lasse Knudsen
    Thread

    Solved Partially clogged nozzle and replacement nozzle

    Greetings, I have what i suspect is a partially clogged nozzle, i can push filament through but its not as easy as im used to, and, as i want to...
    Thread by: Lasse Knudsen, Jul 12, 2016, 4 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again