1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Connor1998
    Post

    Upgrade and refit of my R1

    Hey man, Did you ever get to documenting the firmware updates on this upgrade?
    Post by: Connor1998, Nov 28, 2021 in forum: Mods and Upgrades
  2. Connor1998
    Post

    Solved ALL axes homing centers off after E3D v6 install

    @mark tomlinson Do you have a list of all G & M codes used for R1+ with Marlin firmware? Also, I am now looking to install the LCD screen I have...
    Post by: Connor1998, Nov 4, 2021 in forum: Troubleshooting
  3. Connor1998
    Post

    Solved ALL axes homing centers off after E3D v6 install

    So, I seem to have fixed the problem and I am very confused but elated. I was doing exactly what you just said, manually pressing the x limit...
    Post by: Connor1998, Nov 4, 2021 in forum: Troubleshooting
  4. Connor1998
    Post

    Solved ALL axes homing centers off after E3D v6 install

    @mark tomlinson This is the endstop status. "M119 x_min: TRIGGERED y_min: open z_min: TRIGGERED M105...." At this time the extruder sits at the...
    Post by: Connor1998, Nov 4, 2021 in forum: Troubleshooting
  5. Connor1998
    Post

    Solved ALL axes homing centers off after E3D v6 install

    So, I have not installed any differing firmware than what was stock. I have checked wiring on all of the switches and it is all correct. I based...
    Post by: Connor1998, Nov 2, 2021 in forum: Troubleshooting
  6. Connor1998
    Post

    Solved ALL axes homing centers off after E3D v6 install

    It seems as so all of the limit switches are working. At least the Z and Y, though their home positions are significantly off. The X-axis is odd...
    Post by: Connor1998, Oct 27, 2021 in forum: Troubleshooting
  7. Connor1998
    Thread

    Solved ALL axes homing centers off after E3D v6 install

    Hi Robo 3D community. I just recently installed the E3D v6 hotend to my robo 3D R1+ And everything works as should.. except for the home positions...
    Thread by: Connor1998, Oct 24, 2021, 17 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again