1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. JOSEPH D SUPLICKI
    Post

    Unresolved X axis just wiggles/vibrates

    Yeah, I meant back and forth not up and down for the Y axis But I did get it working. I will be doing a test print here in a minute. I put all...
    Post by: JOSEPH D SUPLICKI, Jan 24, 2022 in forum: Troubleshooting
  2. JOSEPH D SUPLICKI
    Post

    Unresolved X axis just wiggles/vibrates

    Well.... it got weirder. I made sure that the wires matched the originals and the X did nothing, Going to pull out the multi meter and test...
    Post by: JOSEPH D SUPLICKI, Jan 23, 2022 in forum: Troubleshooting
  3. JOSEPH D SUPLICKI
    Post

    Unresolved X axis just wiggles/vibrates

    Ok I'm back, Life, holidays, etc. So I am back at this, trying to get this to work. So I think I am losing my mind. 1) I ordered 2 different...
    Post by: JOSEPH D SUPLICKI, Jan 23, 2022 in forum: Troubleshooting
  4. JOSEPH D SUPLICKI
    Post

    Unresolved X axis just wiggles/vibrates

    you are probably right, I used these because the pinning matched. DAOKI 5Pcs Stepper Motor Driver Module A4988 for Reprap 3D Printer StepStick...
    Post by: JOSEPH D SUPLICKI, Nov 9, 2021 in forum: Troubleshooting
  5. JOSEPH D SUPLICKI
    Post

    Unresolved X axis just wiggles/vibrates

    Ok, So I got the new boards in and was able to install them 1) now when I move the Z-axis it moves fine if I move it 1mm at a time if it tries to...
    Post by: JOSEPH D SUPLICKI, Nov 8, 2021 in forum: Troubleshooting
  6. JOSEPH D SUPLICKI
    Post

    Unresolved X axis just wiggles/vibrates

    thank for the comments, I have ordered new stepper drivers, will update here on Saturday (10/30/21)
    Post by: JOSEPH D SUPLICKI, Oct 27, 2021 in forum: Troubleshooting
  7. JOSEPH D SUPLICKI
    Thread

    Unresolved X axis just wiggles/vibrates

    So I have had my R1 for years and everything has worked fine with no issues. I recently moved and packed it back up in the original packaging and...
    Thread by: JOSEPH D SUPLICKI, Oct 24, 2021, 15 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again