1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Doug Gebhart
    Post

    Community Favorite E3D v6 Information and Installation Guide

    OK, forgive me if this sounds ignorant: Why can't I take the stock electrical connection clips from the old parts, and solder them onto the new...
    Post by: Doug Gebhart, Mar 19, 2018 in forum: Mods and Upgrades
  2. Doug Gebhart
    Post

    Size of Screw That Holds the Filament Latch

    I do mean that one, thank you!
    Post by: Doug Gebhart, Apr 28, 2017 in forum: General Questions
  3. Doug Gebhart
    Thread

    Size of Screw That Holds the Filament Latch

    Can anyone tell me the size of the screw that holds the filament latch to the extruder assembly? I mean the one at the bottom, not the ones at...
    Thread by: Doug Gebhart, Apr 28, 2017, 2 replies, in forum: General Questions
  4. Doug Gebhart
    Post

    Unresolved Rear Right Corner of Bed Has Prints Not Adhering

    OK I will give that a try.
    Post by: Doug Gebhart, Mar 23, 2017 in forum: Troubleshooting
  5. Doug Gebhart
    Post

    Unresolved Rear Right Corner of Bed Has Prints Not Adhering

    So I just looked, and the heating element is under that area, or at least I feel a bulge under that area. EDIT: word
    Post by: Doug Gebhart, Mar 23, 2017 in forum: Troubleshooting
  6. Doug Gebhart
    Post

    Unresolved Rear Right Corner of Bed Has Prints Not Adhering

    Here is my start up g-code: M92 Z2560 ; set extruder calibration M565 Z-0.775 ; set the offset for auto-leveling mechanism G28 ; home all axes...
    Post by: Doug Gebhart, Mar 23, 2017 in forum: Troubleshooting
  7. Doug Gebhart
    Thread

    Unresolved Rear Right Corner of Bed Has Prints Not Adhering

    So recently on one of my Robo3D R1s, the back right corner of the bed is not adhering. It looks like the z-offset is incorrect, and the print...
    Thread by: Doug Gebhart, Mar 23, 2017, 6 replies, in forum: Troubleshooting
  8. Doug Gebhart
    Post

    PLA Printing for Aquarium Decor

    I actually ended up going in a completely different direction. I took some huge (4") PVC pipe tees and coated them with aquarium rock using fish...
    Post by: Doug Gebhart, Jun 23, 2016 in forum: Projects
  9. Doug Gebhart
    Post

    Unresolved Z-axis stuttering

    Ok, I tried to calibrate the stepper drivers and had no luck. Either I don't have a fine enough touch to calibrate it exactly to where it needs...
    Post by: Doug Gebhart, Mar 9, 2016 in forum: Troubleshooting
  10. Doug Gebhart
    Thread

    Unresolved Z-axis stuttering

    I have a problem where whenever I try to move the z-axis, the stepper motors just seem to stutter. They stutter for about 2 seconds, then the...
    Thread by: Doug Gebhart, Mar 4, 2016, 4 replies, in forum: Troubleshooting
Showing results 1 to 10 of 10
Search Again