1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Hazrd
    Post

    Solved First Layer | Under Extrusion?

    Turns out the Z axis offset wasn't actually being set. Fixed it and now its off the print bed and laying filament again. Sadly its going to need...
    Post by: Hazrd, May 14, 2016 in forum: Troubleshooting
  2. Hazrd
    Post

    Solved First Layer | Under Extrusion?

    I tried setting the Z Offset again Reinstalled the firmware in this post:...
    Post by: Hazrd, May 14, 2016 in forum: Troubleshooting
  3. Hazrd
    Thread

    Solved First Layer | Under Extrusion?

    Hot end: e3d v6 Filament: HATCHETBOX 1.75mm WHITE ABS TEMP: 235c BED: 70c COOLING: No fan, I'm trying to print a fan shroud to fix this. SLIC3R...
    Thread by: Hazrd, May 14, 2016, 2 replies, in forum: Troubleshooting
  4. Hazrd
    Post

    Solved No power / power supply

    Thanks for the information, thats what I was thinking it was for. I looked inside a known working power supply and it globs of that inside of it...
    Post by: Hazrd, May 7, 2016 in forum: Troubleshooting
  5. Hazrd
    Post

    Solved No power / power supply

    I have one now, I can't remember if I had one before I moved or not. Previous roommates kitty chewed on some wires so its been out of commission...
    Post by: Hazrd, May 7, 2016 in forum: Troubleshooting
  6. Hazrd
    Post

    Solved No power / power supply

    I got one day shipping from Amazon, so I'll have a replacement here tomorrow. I'm mostly just curious and don't like not knowing WHY something...
    Post by: Hazrd, May 7, 2016 in forum: Troubleshooting
  7. Hazrd
    Post

    Solved No power / power supply

    Did the new power supply have anything like that inside of it? Also, do you know what it is?
    Post by: Hazrd, May 7, 2016 in forum: Troubleshooting
  8. Hazrd
    Thread

    Solved No power / power supply

    No green light on the power supply. Tried two power cables. Tested the fuse by the plug on the back and its ok. Tested the fuse on the power...
    Thread by: Hazrd, May 7, 2016, 23 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again