1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. bubbletron
    Post

    Answered Connected but can't communicate

    Thanks for the response! I'll give the new Arduino a try and hopefully remember to report back. Thanks for all the help!
    Post by: bubbletron, May 15, 2020 in forum: Troubleshooting
  2. bubbletron
    Post

    Answered Connected but can't communicate

    while I am looking at these, should I spend the $39 on the one from Arduino or the ~$15 ones from Amazon? There can't be that much of a difference...
    Post by: bubbletron, May 14, 2020 in forum: Troubleshooting
  3. bubbletron
    Post

    Answered Connected but can't communicate

    Thanks for the response! I don't typically print via USB, but I tried to send a print to the printer and it only showed SENT: G90 SENT: M82. The...
    Post by: bubbletron, May 14, 2020 in forum: Troubleshooting
  4. bubbletron
    Thread

    Answered Connected but can't communicate

    Hello all! I have a ROBO R1 v2 with the and I am unable communicate with the printer via USB. I can connect to the computer and it will read all...
    Thread by: bubbletron, May 14, 2020, 7 replies, in forum: Troubleshooting
  5. bubbletron
    Post

    Solved Z axis height is off

    Oh oops! I fixed mine already in the XXL lcd controller.. I thought the first link took you straight to the download or something. Every time I...
    Post by: bubbletron, May 25, 2016 in forum: Troubleshooting
  6. bubbletron
    Post

    Solved Z axis height is off

    Not to bring this up from the dead but I am having the same issue once I installed the XXL controller. The only reason I am commenting now is...
    Post by: bubbletron, May 25, 2016 in forum: Troubleshooting
  7. bubbletron
    Post

    Unanswered layer adhesion problems

    So I have to pack my printer up tonight but I think I'm finally getting in the right direction. I noticed a pattern that I can 100% recreate. I...
    Post by: bubbletron, Feb 29, 2016 in forum: Troubleshooting
  8. bubbletron
    Post

    Unanswered layer adhesion problems

    [MEDIA] 100mm extrusion. you can see that it is having some hiccups. i promise the hobbed bolt and everything in that area is clean. Still not...
    Post by: bubbletron, Feb 25, 2016 in forum: Troubleshooting
  9. bubbletron
    Post

    Unanswered layer adhesion problems

    Yes and yes. sorry I was writing a novel and didn't see your question :)
    Post by: bubbletron, Feb 25, 2016 in forum: Troubleshooting
  10. bubbletron
    Post

    Unanswered layer adhesion problems

    Thanks for the input, I'll get to checking everything over while I wait to see if anyone else has something. I am speculating that this may have...
    Post by: bubbletron, Feb 25, 2016 in forum: Troubleshooting
  11. bubbletron
    Thread

    Unanswered layer adhesion problems

    Hello everyone! First off I have the Robo 3d R1v2 with the e3d v6. I have had countless beautiful prints from this machine until recently. I am...
    Thread by: bubbletron, Feb 25, 2016, 6 replies, in forum: Troubleshooting
Showing results 1 to 11 of 11
Search Again