1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. 90AWDeclipse
    Post

    Unanswered Temps freeze during leveling then Error

    Thanks I will try to figure this out
    Post by: 90AWDeclipse, Mar 23, 2016 in forum: Troubleshooting
  2. 90AWDeclipse
    Post

    Unanswered Temps freeze during leveling then Error

    I used the code you supplied, but it still drops temp. It's right around 190 so I was thinking if I make it a little lower it won't cut the...
    Post by: 90AWDeclipse, Mar 23, 2016 in forum: Troubleshooting
  3. 90AWDeclipse
    Post

    Unanswered Temps freeze during leveling then Error

    I want to lower it from 190 to 175. How do I go about doing this?
    Post by: 90AWDeclipse, Mar 23, 2016 in forum: Troubleshooting
  4. 90AWDeclipse
    Post

    Unanswered Temps freeze during leveling then Error

    Can I have some more guidance with changing the min extruder temp?
    Post by: 90AWDeclipse, Mar 23, 2016 in forum: Troubleshooting
  5. 90AWDeclipse
    Post

    Unanswered Temps freeze during leveling then Error

    I entered the start up GCode and it still drops temp. Once it goes past the start up and starts the auto leveling the temps freeze. Once it starts...
    Post by: 90AWDeclipse, Mar 23, 2016 in forum: Troubleshooting
  6. 90AWDeclipse
    Post

    Unanswered Temps freeze during leveling then Error

    Why do you think this just started happening though? I will try this when I get home from work. Thanks
    Post by: 90AWDeclipse, Mar 22, 2016 in forum: Troubleshooting
  7. 90AWDeclipse
    Post

    Unanswered Temps freeze during leveling then Error

    It's the pla+abs model I bought it in February of 2015. No upgrades, and the heater and thermistor are in place and I have them zip tied also.
    Post by: 90AWDeclipse, Mar 22, 2016 in forum: Troubleshooting
  8. 90AWDeclipse
    Thread

    Unanswered Temps freeze during leveling then Error

    Iv'e been having this problem for a while now, but I was working around it. I always preheat my bed and extruder before a print. Once I start a...
    Thread by: 90AWDeclipse, Mar 22, 2016, 21 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again