1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. wickemu
    Thread

    Answered All drivers are off by the exact same amount

    I've been in the process of calibrating my printer and I've discovered that every motor of my printer is off by the exact same amount. That seems...
    Thread by: wickemu, Sep 19, 2017, 18 replies, in forum: Troubleshooting
  2. wickemu
    Thread

    Solved Z-sensing component falls behind other Z pieces, causing bizarre layer height issues

    Pictures, because it's hard to grasp what I'm talking about without seeing it. Notice how it's normal at the bottom, then gets stretched further...
    Thread by: wickemu, Jul 6, 2017, 15 replies, in forum: Troubleshooting
  3. wickemu
    Thread

    Solved Wobbling Along Y Axis

    Picture attached. The X and Z axes look great, but Y is inconsistent. What steps can I take to improve it? This printer came with a broken Y...
    Thread by: wickemu, Jun 19, 2017, 26 replies, in forum: Troubleshooting
  4. wickemu
    Thread

    Solved Determining Robo 3D R1 version for fan shroud and/or "nozzle sock"?

    I'm having an issue with my prints not being cooled quickly enough to set and my extruder cooling too quickly from the print fan. I'm therefore...
    Thread by: wickemu, Jun 19, 2017, 6 replies, in forum: General Questions
  5. wickemu
    Thread

    Solved How do I reset autolevel memory?

    I made a dumb mistake with a recent print - right before it started the autolevel, I noticed a lot of filament gumming up on the nozzle. I...
    Thread by: wickemu, Jun 17, 2017, 16 replies, in forum: Troubleshooting
  6. wickemu
    Thread

    Recommended first steps with an old stock Robo 3D?

    TL;DR: Have an untouched 2-year-old Robo 3D. Now what? Freezes mid-print currently. I got a Robo 3D as a present in 2015 - I was very uneducated...
    Thread by: wickemu, Jun 16, 2017, 12 replies, in forum: General Questions
Showing results 1 to 6 of 6
Search Again