1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Jason Kish
    Post

    Start Extruder Heating After Bed Leveling

    Thanks for the input, but where do I find those settings for the R2 or Cura. I haven't modified any code yet with the new printer.
    Post by: Jason Kish, Jul 15, 2017 in forum: Troubleshooting
  2. Jason Kish
    Thread

    Start Extruder Heating After Bed Leveling

    Has anyone been able to find the settings or find a solution to start the extruder heating after the bed leveling is complete? The extruder...
    Thread by: Jason Kish, Jul 13, 2017, 5 replies, in forum: Troubleshooting
  3. Jason Kish
    Post

    Issues with my R2 that I have observed

    Thanks for the help everyone. I was able to get the calibration cube printed and I think I have a good start towards more elaborate prints. Hope...
    Post by: Jason Kish, Jun 1, 2017 in forum: Troubleshooting
  4. Jason Kish
    Post

    Issues with my R2 that I have observed

    So the last fine tune seems to have worked. But now I can't get through a few layers without the filament saying it has run out. Any suggestions?
    Post by: Jason Kish, Jun 1, 2017 in forum: Troubleshooting
  5. Jason Kish
    Post

    Issues with my R2 that I have observed

    I did exactly that and haven't changed anything except now it's working. Now the big problem is my filament is saying it is out and stopping the...
    Post by: Jason Kish, Jun 1, 2017 in forum: Troubleshooting
  6. Jason Kish
    Post

    Issues with my R2 that I have observed

    Also, my filament is stating it has run out after 30 seconds of printing, even though it has plenty and enough feed. And my webcam will not work...
    Post by: Jason Kish, Jun 1, 2017 in forum: Troubleshooting
  7. Jason Kish
    Post

    Issues with my R2 that I have observed

    Just redid the fine tune after an hour break and it is closer, but still not as close as I set it with fine tune, which was at -7.4
    Post by: Jason Kish, Jun 1, 2017 in forum: Troubleshooting
  8. Jason Kish
    Post

    Issues with my R2 that I have observed

    So I just got mine and was having the high value even after the Z Wizard and Fine Tune. Any suggestions? Also, I have not been able to get any...
    Post by: Jason Kish, Jun 1, 2017 in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again