1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. hybridman
    Post

    Solved HELP! Very frustrated with my printer

    Yes the new hotend worked very well - solved a lot of problesm as well as the bigger cooling fan under the case. Still having sporadic issues...
    Post by: hybridman, Nov 30, 2017 in forum: Troubleshooting
  2. hybridman
    Post

    Solved Z axis problems

    Wow- I thought the box it came in said it was an R1+, but its been awhile. My bad. Thx.
    Post by: hybridman, Nov 30, 2017 in forum: Troubleshooting
  3. hybridman
    Post

    Solved Z axis problems

    I found the problem that I have not seen addressed yet! I took the printer apart to check all connections/parts. After closer inspection I saw...
    Post by: hybridman, Nov 29, 2017 in forum: Troubleshooting
  4. hybridman
    Post

    Solved Z axis problems

    I did that first thing. Wires are connected, nothing in the way of movement. Nuts are properly seated and limit switches are properly positioned...
    Post by: hybridman, Nov 29, 2017 in forum: Troubleshooting
  5. hybridman
    Thread

    Solved Z axis problems

    I was hoping some of you seasoned users can help me out- really frustrated. Using my Robo-3D R1+ Matter Control 5.1 I have printed a part that...
    Thread by: hybridman, Nov 28, 2017, 5 replies, in forum: Troubleshooting
  6. hybridman
    Post

    Solved HELP! Very frustrated with my printer

    AT this point I will try anything. FYI- I have always printed the same pieces in black ABS at 240 with bed at 90. Today I heated it up to 250 for...
    Post by: hybridman, Jan 1, 2017 in forum: Troubleshooting
  7. hybridman
    Post

    Solved HELP! Very frustrated with my printer

    It was the last time I checked, I will look again. I think I have some spare fans at the shop if I need them. Would that cause this problem? I...
    Post by: hybridman, Jan 1, 2017 in forum: Troubleshooting
  8. hybridman
    Thread

    Solved HELP! Very frustrated with my printer

    Hey guys, I could really use some advice. I'm about to throw this thing through the window. I have the ROBO3D R1. I had a lot of extrusion...
    Thread by: hybridman, Jan 1, 2017, 7 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again