1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. nonmindo
    Post

    Unanswered Simplify3D and Z axis

    I think maybe the next testing step would be to load up a model in MC, test print, check to make sure z-axis is leveling during print, then export...
    Post by: nonmindo, Nov 22, 2016 in forum: Troubleshooting
  2. nonmindo
    Post

    Unanswered Simplify3D and Z axis

    so it doesnt look like any "maths" is done like i thought, searched for "M565" in the MC gcode output M565 Z-0.7 I tried this in S3D and the...
    Post by: nonmindo, Nov 22, 2016 in forum: Troubleshooting
  3. nonmindo
    Post

    Unanswered Simplify3D and Z axis

    are ya'll discussing my post or the OP, just making sure lol as for me, I'm using whatever firmware was updated when i installed the R1+Plus...
    Post by: nonmindo, Nov 21, 2016 in forum: Troubleshooting
  4. nonmindo
    Post

    Unanswered Simplify3D and Z axis

    I'm having a similar issue but I don't know if its gcode related or not, I also just recently got S3D and MC is working just fine, my problem is...
    Post by: nonmindo, Nov 21, 2016 in forum: Troubleshooting
  5. nonmindo
    Post

    Request: Radial part cooling fan for E3Dv6 and stock carriage w/o losing clearance

    I would but as it's designed he mentioned it looses some print volume because it hits the bottom edge of the RoBo cover when it goes too far up,...
    Post by: nonmindo, Jul 12, 2016 in forum: Mods and Upgrades
  6. nonmindo
    Thread

    Request: Radial part cooling fan for E3Dv6 and stock carriage w/o losing clearance

    I found this on thingiverse, but it looses some build volume because it is too bulky, I was wondering if anyone could make something similar or...
    Thread by: nonmindo, Jul 11, 2016, 2 replies, in forum: Mods and Upgrades
  7. nonmindo
    Post

    E3D Titan Extruder

    Super excited to see development for this, I was thinking about picking up one but was worried about compatibility with the existing carriage, now...
    Post by: nonmindo, Apr 25, 2016 in forum: Mods and Upgrades
Showing results 1 to 7 of 7
Search Again