1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. ballhogjoni
    Thread

    Popping sound?

    My printer is making a popping sound when it travels on the X axis. I can't pinpoint the exact location of the sound. I'm not sure if it's gears...
    Thread by: ballhogjoni, Feb 9, 2022, 1 replies, in forum: Troubleshooting
  2. ballhogjoni
    Thread

    Auto Bed Leveling?

    My auto bed leveling doesn't seem to work. The printer goes through the motions of auto bed leveling before each print, but the bed is just a...
    Thread by: ballhogjoni, Feb 18, 2021, 3 replies, in forum: General Questions
  3. ballhogjoni
    Thread

    Z-Offset Wizard stuck at step 1 of 4

    See picture. It's been like this for 10 minutes or more.
    Thread by: ballhogjoni, Mar 24, 2020, 63 replies, in forum: Troubleshooting
  4. ballhogjoni
    Thread

    Error When Heating the Bed and Hotend

    I'm trying to print some glow in the dark ABS but I keep running into an error that shuts down the connection with OctoPrint. This shutdown tops...
    Thread by: ballhogjoni, Jul 1, 2017, 4 replies, in forum: Troubleshooting
  5. ballhogjoni
    Thread

    R2 not reading USB drive

    I've added some new STL files to the USB drive that came with the printer but I plug it in and it doesn't read the files. What have I done wrong?...
    Thread by: ballhogjoni, Jun 21, 2017, 24 replies, in forum: Troubleshooting
  6. ballhogjoni
    Thread

    Screen unresponsive?

    I've contacted support with no answer that has worked. My screen only responds to finger touch and stylus touch about 5% of the time. I've turned...
    Thread by: ballhogjoni, Jun 20, 2017, 8 replies, in forum: Troubleshooting
  7. ballhogjoni
    Thread

    R2 Web Cam?

    Hey does anyone know how to setup the webcam? I can't seem to find it in the control screen options.
    Thread by: ballhogjoni, Jun 3, 2017, 2 replies, in forum: General Questions
  8. ballhogjoni
    Thread

    Reset printer to factory default?

    Is there a way to reset printer to factory default?
    Thread by: ballhogjoni, Jun 3, 2017, 2 replies, in forum: Troubleshooting
  9. ballhogjoni
    Thread

    Extruder to far from print bed

    I've gone through the z calibration twice and it was -8.2 and -9.0. When I go to do one of the default test prints the extruder is about 2-3mm...
    Thread by: ballhogjoni, Jun 3, 2017, 6 replies, in forum: Troubleshooting
  10. ballhogjoni
    Thread

    Unresolved New XXL LCD Causing Bed to Shutdown

    So I got the XXL LCD from print solid and its causing the bed to shutdown when it hits 70 degrees. I've tested this by having it connected without...
    Thread by: ballhogjoni, Aug 21, 2016, 14 replies, in forum: Troubleshooting
  11. ballhogjoni
    Thread

    Unanswered For some reason the printer stops mid print

    The printer stops mid print for a few seconds and then continues. This causes the extruder to leave excess filament where it stop and also melts...
    Thread by: ballhogjoni, Aug 16, 2016, 24 replies, in forum: Troubleshooting
Showing results 1 to 11 of 11
Search Again