1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Bushwookie
    Post

    Solved E-3d-v6 jam

    okay, good to know. Thank you! I'll try that before taking a drill to anything. PTFE tubing i wont even bother undoing. i can get 2 metres of...
    Post by: Bushwookie, Sep 11, 2016 in forum: Troubleshooting
  2. Bushwookie
    Post

    Solved E-3d-v6 jam

    Hi Geof, Thank you for the quick reply. I have heated up the end, and i managed to get the teflon tubing out, but it unfortunately has a pretty...
    Post by: Bushwookie, Sep 11, 2016 in forum: Troubleshooting
  3. Bushwookie
    Thread

    Solved E-3d-v6 jam

    Hello all, I recently purchased and installed the e3d v6 hotend for 1.75mm filament, and installed it on my robo3d R1.It has now suffered a jam,...
    Thread by: Bushwookie, Sep 10, 2016, 7 replies, in forum: Troubleshooting
  4. Bushwookie
    Post

    Solved Z-axis lifting less than it should

    Thank you very much! that seems to have done the trick!
    Post by: Bushwookie, Apr 11, 2016 in forum: Troubleshooting
  5. Bushwookie
    Post

    Solved Z-axis lifting less than it should

    It is a completely stock R1 (not R1+) save for the following modifications: -New ramps 1.4 board (ordered through robo 3d) -New 0.25mm extruder...
    Post by: Bushwookie, Apr 11, 2016 in forum: Troubleshooting
  6. Bushwookie
    Thread

    Solved Z-axis lifting less than it should

    Hello, I own a Robo3d R1, and I noticed that the Z-axis does not seem to lift nearly as much as it should when given commands. I recently...
    Thread by: Bushwookie, Apr 10, 2016, 5 replies, in forum: Troubleshooting
  7. Bushwookie
    Post

    Unresolved Extruder not heating up.

    yea, stepper motors still run, everything else seems to be fine. The weird thing is that its a very recent thing. it only occurred when I...
    Post by: Bushwookie, Mar 23, 2016 in forum: Troubleshooting
  8. Bushwookie
    Post

    Unresolved Extruder not heating up.

    Hello all. It seems I am having the same problem, so no use posting a new thread. I followed all the above steps, and found that when i...
    Post by: Bushwookie, Mar 23, 2016 in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again