1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Lael
    Post

    Unresolved Robo R1+ prints not centering on y axis as shown in Mattercontrol

    Nope, mine was fine on that end. It was just really screwy. After it started happening, I even tried to trick the machine (in the G code) into...
    Post by: Lael, Mar 30, 2016 in forum: Troubleshooting
  2. Lael
    Post

    Unresolved Robo R1+ prints not centering on y axis as shown in Mattercontrol

    To clarify too, my That is what mine did as well. And to reiterate, when this started occurring for me, I was still having Mattercontrol center...
    Post by: Lael, Mar 30, 2016 in forum: Troubleshooting
  3. Lael
    Post

    Unresolved Robo R1+ prints not centering on y axis as shown in Mattercontrol

    Comparing the release notes to when I originally downloaded the software, I think I had 1.4. Anyway, I manually deleted the Mattercontrol...
    Post by: Lael, Mar 29, 2016 in forum: Troubleshooting
  4. Lael
    Post

    Unresolved Robo R1+ prints not centering on y axis as shown in Mattercontrol

    Well, I did finally find the problem. It was (drum roll) a software issue. Mattercontrol would home properly, it would also level the bed at the...
    Post by: Lael, Mar 28, 2016 in forum: Troubleshooting
  5. Lael
    Post

    Unresolved Robo R1+ prints not centering on y axis as shown in Mattercontrol

    Everything seems secure in terms of the hardware, and there have been no unusual noises, or any obvious anomalies. As you had suggested, I had...
    Post by: Lael, Feb 17, 2016 in forum: Troubleshooting
  6. Lael
    Post

    Unresolved Robo R1+ prints not centering on y axis as shown in Mattercontrol

    Of course they don't happen without reason, that's is why I posted on the forum after looking several places first and finding no solution. And,...
    Post by: Lael, Feb 16, 2016 in forum: Troubleshooting
  7. Lael
    Post

    Unresolved Robo R1+ prints not centering on y axis as shown in Mattercontrol

    Thanks for the response. And I do actually believe there must be something to troubleshoot. I am aware of the print bed (and the heat area) being...
    Post by: Lael, Feb 16, 2016 in forum: Troubleshooting
  8. Lael
    Thread

    Unresolved Robo R1+ prints not centering on y axis as shown in Mattercontrol

    Hey there, I've been printing on this printer since October with very few issues, but now all of my prints are orienting way farther back than...
    Thread by: Lael, Feb 16, 2016, 34 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again