1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved 357 degree extruder temp

Discussion in 'Troubleshooting' started by Jay312, Mar 25, 2017.

Thread Status:
Not open for further replies.
  1. Jay312

    Jay312 Member

    Joined:
    Mar 18, 2017
    Messages:
    64
    Likes Received:
    10
    Finally found my grub screw now I'm dealing with a 357 degree extruder temp and it's not even a little heated? Any ideas
     
    #1 Jay312, Mar 25, 2017
  2. Jay312

    Jay312 Member

    Joined:
    Mar 18, 2017
    Messages:
    64
    Likes Received:
    10
    Shit loose wire I think shit
     
    #2 Jay312, Mar 25, 2017
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Thermistor bad or wiring to the thermistor bad normally

    Sent from my SAMSUNG-SM-G930A using Tapatalk
     
    #3 mark tomlinson, Mar 26, 2017
  4. Nathan Elverud

    Nathan Elverud New Member

    Joined:
    Dec 22, 2016
    Messages:
    24
    Likes Received:
    1
    A while ago I had the problem of it saying the hot end was that exact same temperature and it was because I had the connectors for the thermistor and heater switched around.
     
    #4 Nathan Elverud, Mar 26, 2017
  5. Jay312

    Jay312 Member

    Joined:
    Mar 18, 2017
    Messages:
    64
    Likes Received:
    10
    My wires must have been loose or touching somehow. thats what it was
     
    #5 Jay312, Mar 27, 2017
Thread Status:
Not open for further replies.

Share This Page