1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Anyone tried shrinkwrap?

Discussion in 'Troubleshooting' started by OutsourcedGuru, Jun 3, 2017.

  1. OutsourcedGuru

    OutsourcedGuru Active Member

    Joined:
    Jun 3, 2017
    Messages:
    752
    Likes Received:
    141
    Was thinking that the extruder produces enough heat over the span of a printout that if you covered the front of the Robo C2 with shrinkwrap that the internal temperature might be a little more even. Don't know if this is good or not but it might lower the warping in some cases.

    Or would this just cause too much work for the fans?
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    If printing in pla you dont want the heat. If abs and some iyher materials you do so your shrink wrap idea may help with those. Be cautious of static electricity
     
  3. OutsourcedGuru

    OutsourcedGuru Active Member

    Joined:
    Jun 3, 2017
    Messages:
    752
    Likes Received:
    141
    I meant, as in: cover the front door opening. I can't imagine there being any static issues since it's not moving at all nor would it come into contact with moving parts.
     
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    More so meant when putting the wrap on and taking it off. :D
     
  5. OutsourcedGuru

    OutsourcedGuru Active Member

    Joined:
    Jun 3, 2017
    Messages:
    752
    Likes Received:
    141
    Geof likes this.

Share This Page