1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Bed Leveling

Discussion in 'Troubleshooting' started by VigilantWookie, Feb 14, 2020.

  1. VigilantWookie

    VigilantWookie New Member

    Joined:
    Feb 6, 2020
    Messages:
    13
    Likes Received:
    0
    Running through the bed leveling wizard, and when I get to the back two screws on the print bed, and cannot get the print surface even remotely close to the extruder before I run out of screw. Am I doing something wrong (definitely possible)?
     
    #1 VigilantWookie, Feb 14, 2020
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, Feb 14, 2020
  3. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    #3 tkoco, Feb 14, 2020
    Geof and mark tomlinson like this.
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    I don't use the bed leveling wizard since it is broken on my R2 (result of using a newer version of Marlin firmware).
     
    #4 WheresWaldo, Feb 19, 2020

Share This Page