1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Bed will not level

Discussion in 'Troubleshooting' started by Lance Weston, Apr 17, 2022.

  1. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    664
    Likes Received:
    230
    My bed would just not level properly. After much frustration I observed that the bed fits over the metal plate below. I took a piece of paper and ran it between the overlapping bed plastic and the metal frame. Sure enough the paper was binding between the two. I took a grinder and ground the plastic from the bed until it was above the metal plate below. That fixed my problem, I could now easily adjust the bed.
     

Share This Page