1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Blobs and boogers on one side, bad top layers.

Discussion in 'Troubleshooting' started by PACNOR RC AEROSYSTEMS, Apr 3, 2016.

  1. PACNOR RC AEROSYSTEMS

    PACNOR RC AEROSYSTEMS Member

    Joined:
    Jan 2, 2016
    Messages:
    106
    Likes Received:
    18
    Okay so I tried a brand new spool as requested. The problem is still there. This only happens on one side of the print and my top layers look horrendous now. This is not a double post.



    IMAG0175.jpg
     
    #1 PACNOR RC AEROSYSTEMS, Apr 3, 2016
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I'd check for leaks from the hot end and over extrusion.hows the first layer going down?
     
    #2 Geof, Apr 4, 2016
  3. KTMDirtFace

    KTMDirtFace Well-Known Member

    Joined:
    May 18, 2015
    Messages:
    1,247
    Likes Received:
    461
    Looks like a autoleveling issue to me like its trying to print too close on the right side for some reason. I had this problem I had to shim my bed to fix it.
     
    #3 KTMDirtFace, Apr 4, 2016
    Geof likes this.
  4. PACNOR RC AEROSYSTEMS

    PACNOR RC AEROSYSTEMS Member

    Joined:
    Jan 2, 2016
    Messages:
    106
    Likes Received:
    18
    Yeah I fixed it. I just did a manual level and adjusted the screws until they touched the bed.
     
    #4 PACNOR RC AEROSYSTEMS, Apr 12, 2016
  5. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Glad to hear your up and running . Like @KTMDirtFace said I also had to shim my bed.
     
    #5 Geof, Apr 12, 2016

Share This Page