1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Calibrating Stepper Motors

Discussion in 'General Questions' started by JEM, Jan 15, 2025.

  1. JEM

    JEM New Member

    Joined:
    May 12, 2024
    Messages:
    11
    Likes Received:
    2
    Complete novice at this hobby. I am using MatterControl via a usb cable, to run my printer (Robo3d R1+Plus). Can one change the values for calibrating the stepper motors using the code shown in options, in MatterControl? This being line M92 X-Y-Z-and E. Thank you for any insight you my have to share.
    John
     
    #1 JEM, Jan 15, 2025
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    24,007
    Likes Received:
    7,346
    No clue on Matter Control, normally you calibrate the stepper driver boards and that is it. Not sure what they are doing for the stepper motors -- maybe they are adapting the drive signal? Better off asking in the matter control forum:

    https://www.matterhackers.com/community

    (yes it is slow to load)
     
    #2 mark tomlinson, Jan 25, 2025

Share This Page