1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Can't get temp higher than 85 in my bed

Discussion in 'Troubleshooting' started by crazas, Mar 25, 2017.

  1. crazas

    crazas Member

    Joined:
    May 18, 2015
    Messages:
    66
    Likes Received:
    2
    I have problems with my ABS sticking to the bed, so I tried to raise (after trying every other known to me solution) to increase my bed temp (usually 80) to 90. It just don't go higher than 84 on my R1
    Any solutions?

    Thanks in advance
     
    #1 crazas, Mar 25, 2017
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Maximum temperature designated in the firmware is 85°C so it will not go above that. You can edit the firmware, recompile and re-upload it to your R1 if you want ot increase that upper limit.
     
    #2 WheresWaldo, Mar 26, 2017
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    This was due to the way that batch if R1 machines had the bed wired so while you can fix the limit in the firmware you should sanity check the bed wiring before you do.

    Sent from my SAMSUNG-SM-G930A using Tapatalk
     
    #3 mark tomlinson, Mar 26, 2017
  4. crazas

    crazas Member

    Joined:
    May 18, 2015
    Messages:
    66
    Likes Received:
    2
    But, is 80-84 rnough? can this problem be due to a bad quality ABS?
     
    #4 crazas, Mar 26, 2017

Share This Page