1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Computer slowdown and "Reduce polygons to render".

Discussion in 'Troubleshooting' started by Curtis Wolfe, Mar 12, 2017.

Thread Status:
Not open for further replies.
  1. Curtis Wolfe

    Curtis Wolfe Active Member

    Joined:
    Feb 21, 2017
    Messages:
    254
    Likes Received:
    78
    Something weird happened lastnight. I was trying to bring up a baby Groot. My computer slowed way down and I started getting "Reduce polygons to render". I switched to a Yoda. Same thing. I told it to print anyway and it was studdering. I had to kill the print.
    A total re-boot and a simple print later everything seems fine, but I haven't gone back and attempted the Groot or Yoda again.

    I updated to the latest version of Matter Control the evening before last.

    Is that my cheap laptop getting bogged down?

    Curtis
     
    #1 Curtis Wolfe, Mar 12, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, Mar 12, 2017
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Try changing the detail level of the slice (i.e. layer height) and see.
     
    #3 mark tomlinson, Mar 12, 2017
Thread Status:
Not open for further replies.

Share This Page