1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Connection Interrupted

Discussion in 'Troubleshooting' started by Hellsbells17, Mar 21, 2018.

  1. Hellsbells17

    Hellsbells17 Member

    Joined:
    Aug 10, 2017
    Messages:
    38
    Likes Received:
    6
    Anybody know what is causing this:
     

    Attached Files:

    #1 Hellsbells17, Mar 21, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    One of the heaters is having issues.
    On the R2 I'd guess it is the bed heater and even more specifically the PoGo Pins if you have not replaced the original with the V2 bed.
     
    #2 mark tomlinson, Mar 21, 2018
    Geof likes this.
  3. Hellsbells17

    Hellsbells17 Member

    Joined:
    Aug 10, 2017
    Messages:
    38
    Likes Received:
    6
    Yes I have the original heat bed.
     
    #3 Hellsbells17, Mar 21, 2018
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    If you pull the bed off you can check the pogo pins on the bed bracket to see if any of the springs have broken or are weak.
     
    #4 WheresWaldo, Mar 21, 2018
    Geof likes this.
  5. denisvic

    denisvic New Member

    Joined:
    Sep 18, 2017
    Messages:
    4
    Likes Received:
    2
    I have same problem, it's not bed but extruder.
    It's a PID problem or a cooling too powerful. I tried to lower cooling to 40% with good results. You can also try PID auto tune.
     
    #5 denisvic, Mar 24, 2018

Share This Page