1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Cura Extrusion Multiplier

Discussion in 'General Questions' started by NKakon, May 16, 2016.

  1. NKakon

    NKakon New Member

    Nov 3, 2015
    Likes Received:
    Does anyone know of a way to control the flow rate during a print? I've seen that there's a tweak at Z plugin and from what I've understood that's only usable for changing predetermined properties at predetermined layers of the print. What i'm wondering is if there's a way to change the flow rate as the print is already going like you can do in MatterControl with the extrusion multiplier.

    Thank you in advance,

Share This Page